Home Feedback Search Forum

 

Turret

 Introduction
Press Table
Theory of Operation
Press Identification
Primer Pin
Indexing
Shell Plate
Case Retainer
Primer Depth Setup
Turret
Setting the Dies
Primer Tray
Powder Disk
Final Adjustments
Lubrication
Case Feeder
Calibers Change
Bullet Feeder
Modifications

 

As you look at the edge of the turret you will notice that some of the grooves extend up than the rest of them do. One of these grooves should be is aligned with position for the turret lock bolt after the turret is installed. Position the turret with the smooth side up so that one of these grooves is near the turret lock bolt. Press the turret down into the frame. After it is in place, turn the turret the proper direction to get the groove behind the turret lock bolt and tighten the turret lock bolt. It may be useful to turn the turret back and forth slightly as you tighten the turret lock bolt. As you tighten the turret lock bolt, you will be able to move the turret less and less. Tighten the turret lock bolt firmly with your fingers. It may be useful to use a marker to make a mark on the turret and frame to easy alignment when installing the turret later. VIDEO

 
Send mail to nicknitro71@yahoo.com with questions or comments about this web site.
Copyright 2008 Loadmastervideos
Last modified: 04/11/08